DSG-01-2B3B-D24-N-50,日本YUKEN電磁換向閥
FOR COMPLETE OPERATING INSTRUCTIONS, REFER TO “OPERATORS
INSTRUCTION MANUAL” PUB. EM-0448. （DSG-01-70 SERIES）
★ MOUNTING
No-spring detented models not energized continuously must be installed so that the
spool axis L-L' on pages 1/3 will be horizontal. Other models are not restricted as to
mounting. horizontal.
★ ENERGIZATION除了標準的兩個位置閥門的型號表所示
左，二種閥的位置和兩個偏移位置中的任個。
標準和反向安裝類型使用“b”和電磁線圈“a”分別。請參閱
酒吧：ALA-0402-70-2兩個位置的閥配置備用。
??位置的閥門和個偏移位置（兩個特殊位置
閥）和反向安裝的電磁閥。
??孔板
★孔可以插入在，無論P，A，B或T口。然而，在這種情況下，差壓
在該孔應設置低于3045 PSI。
★情況下的節流孔被插入在T-口，在閥的油箱管路壓力應小于
的zui大的T型線背壓。
★如孔板差壓超過3045 PSI進行特殊設計，咨詢油研
閥門有螺紋P，A，B口。
On double solenoid valves do not energize both at the same time as it will result in
coils burning out.
★ VALVE TANK PORT
Connection of valve tank port to a line where surge pressure is likely to occur is to be
avoided. Piping end of tank line should be submerged in oil.
★ VALVE TIGHTENING TORQUE OF MOUNTING BOLT
44～62 IN?lbs
（Applicable to working pressure more than 3625 PSI : 53～62 IN?lbs）
★ OPERATING FORCE BY MANUAL ACTUATOR
Take care as the operating force by the manual actuator increases in proportion to the
tank line back pressure. （See the below graph.）

DSG-01-2B3B-D24-N-50,日本YUKEN電磁換向閥